Maintain The Characteristics As Calculated

Got a scenario in which during the result recording the characteristics 3 is the summation of the result recorded for the characteristics 1 & 2 in QE51N.  We need to maintain the characteristics 3 as calculated characteristics & enter the formula.

Where can we define characteristics as calculated characteristics & enter the formula?

Answer:

You have to define in the control indicators of the characteristics.

Once you have defined in the characteristics and when you maintain in the inspection plan it will automatically ask you enter the formula in the plan.

Listed below is the list of calculated characteristic:

A0 Measured value for single unit

B0 Arith. mean of measure. values for sample

B1 No. of valid measured values for sample

B2 Share of defective units for sample

B3 No. of defects observed in sample

B4 No. of defective units in sample

B8 Variance of valid meas. values in sample

B9 Minimum valid meas. value in sample

BA Maximum valid meas. value in sample

C0 Arith. mean of measured values for char.

C1 No. of valid measured values for char.

C2 Share of defective units in char.

C3 No. of defects observed in char.

C4 No. of defective units for char.

C5 Upper tolerance range limit

C6 Lower tolerance range limit

C7 Target value of characteristic

C8 Variance of valid meas. values for char.

C9 Minimum valid meas. value for char.

CA Maximum valid meas. value for char.

D0 Function module test

Characteristic 10 stands for the length and characteristic 20 stands for the width. 

Characteristic 30 represents the area and is to be calculated from characteristics 10 and 20.

Characteristic 30 is therefore a calculated characteristic with the following formula:

Example: Area = C00010 * C00020 

'C0' stands for the arithmetic mean value and '0010' or '0020' for the respective characteristic.

SAP QM

Also read
Inspection Points in Defects Recording

Have a SAP QM Problems?
SAP QM Forum - Do you have a SAP QM Question?

SAP QM Books
SAP Quality Management Certification, Interview Questions and Configuration Reference Books

SAP QM Tips
SAP QM Tips and Quality Management Discussion Forum

Main Index
SAP ERP Modules, Basis, ABAP and Other IMG Stuff

All the site contents are Copyright © www.erpgreat.com and the content authors. All rights reserved.
All product names are trademarks of their respective companies.  The site www.erpgreat.com is in no way affiliated with SAP AG. 
Every effort is made to ensure the content integrity. Information used on this site is at your own risk. 
 The content on this site may not be reproduced or redistributed without the express written permission of 
www.erpgreat.com or the content authors.