At plant level in Customisation maintain the following:
1) Plant level - Result Recording
2) Inspection point field combination : 100
3) partial Lot Assign : Partial lot and batch for each inspection point.
4) Proposal for inspection point valuation : Maintain
any of the selectedset coded you have created for 03 inspection or 04 inspection.
Master Data Required
1) Maintain 03 inspection in MM02
2) Selected set for 03 inspection for the particalur plant.
3) Sampling procedure with selection of inspection point as this mandatory.
4) Maintain routing as mentioned below :
1) Go to CA02
2) Go to Header
3) Maintain inspection Point as 150
4) Maintain partial Lot Assign as partial lot assignment according to plant default
5) At Operation level maintain a QM work center (testing) with Control key QM04 (as per your requirement).
6) Double click on the control key and go to Quality Management : Inspection points.
7) Maintain Inspection point completion : Quantity, Valuation and confirmation (as per your need, you can select other options also) press F1 and see the impact of each.
8) Choose time related and keep Tfac 1 and Unit as HR ( As needed).
9) You can select quantity - related also and then maintain the quantity.
10) Selection the QM operation and maintain in the MIC
with above said sampling procedure.
At transaction level
1) Create order co01, release and save . lot will be created.
2) Do the opertion confirmation if there is any operation mentioned in the routing before the qm operation.
3) Go to qa32 -> result -> you will get a pop of all the operation with yellow traingle mentioning QM is active in that operation. double click on the QM operation.
4) Pop will come for entering parial quantity, date time.
5) Enter the details, do the result recording.
6) Save, pop will come for confirmation of quantity.
PS: Step-5 - Take note of what is the control key you are using. Make sure that you have inspection char tick in the control key.
